Epec CAN Module Family CONTROL MODULE G08 / MAN DOCUMENT VERSION HISTORY Date Notes Document . Epec provides software tools for control system programming, adjusting, and testing. From the systems engineering viewpoint, it is not enough to have sufficient. Open and compatible. Embedded control systems are based on PLCopen and CANopen®, which make them easily scalable to meet requirements for both.
|Published (Last):||27 October 2017|
|PDF File Size:||1.95 Mb|
|ePub File Size:||9.14 Mb|
|Price:||Free* [*Free Regsitration Required]|
We believe that we know control systems for challenging conditions and we are able to offer a total solution from control units to project services and designing.
The features of this product should be well documented in machine 20244 control system documents Epec Oy reserves all rights for improvements without prior notice Epec Oy Matinkatu 6 FIN Sein?
epec 2024 control module
The Mini module and the Mini display need the Hub module in order to have the full transient immunity. The pairing is done in application program. The pulse count and pulse frequency can be read from the pulse input channels. In very carefully selected applications a pin of this type can also be used as an input by using the output state monitoring feature. In PLCopen programming environment, there is a word variable in IW area associated with each pin from where the software can read the actual signal magnitude rpec the pin.
These parameters depend on software cycle time. Even if some of the inputs were not used for frequency measurement or pulse counting, these conditions must nevertheless be respected regarding 20024 inputs too. Pulse Input channels Channel 0 1 2 3 4 5 6 7 Pin X3. IP67 classification according to IEC ? All trademarks mentioned in this document are owned by their manufacturers.
Excavator Spare Parts for SANY EPEC 2024 Control Module
Applies to inputs used as normal digital inputs. Violating this rating may lead to application program not noticing all input state transitions Epec Oy reserves all rights for improvements without prior notice Epec Oy Matinkatu 6 FIN Sein?
Violating this rating may lead to application program not noticing all input state transitions. This product complies with those certifications and standards that are listed below. These parameters depend on software cycle time Note 4: There are three variables associated with each pin of this type in IEC programming environment. Additional module cover for wires and connectors is also available E 6.
EPEC controller Manual _Download Manual
There are, for example, outputs which source current and outputs which sink current. In other words, pins connect the load to the ground. The first is one of the QX output bits for controlling the pin as an output. After starting up the module measures only the pulse frequency.
Maximum pulse input frequency 20 kHz. Programming environment CoDeSys 2. Nominal supply voltage 24 VDC? Module temperature Software deadlock is monitored by the hardware watchdog that reboots the module automatically after ms software deadlock. Test method ISOpulse 5?
Inputs are divided into groups by the input impedance configuration. It must be taken care in system design that the output unintentionally switching to on state causes no harm to the system.
In carefully selected applications these pins can also be used as digital inputs. Epec Oy reserves a right to improve its products without a further notice. Puncture hole fastening 7. The shutdown circuit is activated when voltage reaches circa 32 V. However, one or more of them can go beyond specified tolerance. These kinds of pins have a small shunt resistor connected to ground.
PWM frequencies can be configured under software control in groups of e;ec. The manufacturer gives no other warranties whatsoever for the products than the warranty set out in this section and thus the warranty given in this section sets forth the warranty given by the manufacturer in its entirety.
This illustrates the normal way to connect loads when load current measurement is desired. The application program will see there a logical zero when eepec pin is grounded or left open and a logical one when the pin is connected to a positive voltage source.
Operating voltage 10 – 30 VDC? Power feed is restored when supply voltage drops to 30 V. For more information refer to programming manuals.